This generally requires a two step process first to pre drill the roof deck followed by a threaded fastener or spike neither structural nor structural lightweight concrete has much thermal resistance so installers would mop the insulation or fasten through it into the concrete decking.
Concrete roof deck fasteners.
With these fastening methods the only puncture of the membrane is at the anchoring points.
Structural concrete deck fasteners are diamond point non threaded fasteners for hammer in installation of insulation and single ply membranes to structural concrete.
Diamond point corrosion resistant coated carbon steel head.
To extend the life of your tile roof by greatly reducing the penetrations in the chosen underlayment use a tyle tye hurricane strap system tyle tye twisted wire or riness tile tie system.
One story commercial building roof deck is prefab concrete panels.
However when a lightweight structural concrete lwsc roof deck is poured in place it uses significantly more water.
The cd 10 and fluted nails.
Head designed to secure insulation and single ply membrane to gypsum and cementitious wood fiber.
Altenloh brinck co.
Hammer in non threaded fasteners designed to secure insulation and single ply membrane to structural concrete.
The omg cd 10 is a hammer in non threaded fastener with a split bulb design that exerts pressure on hole walls for superior strength and hold power.
Phone 800 443 9602 fax.
I would rather put fasteners through it than depend on adhesive to keep the new roof covering from flying.
Insulation and membranes material.
2105 county road 12c bryan oh 43506.
If pre drilling of the deck substrate is necessary use a hammer drill in impact mode with a 7 32 5 6 mm carbide drill bit.
Traditional fastening methods can leave 200 penetrations in a 10 x 10 roof area.
As for fasteners the fluted nails suggested by.
These carbon steel fasteners have a corrosion resistant coating.
Available in lengths between 2 in and 12 in.
Hard rocks with a low water absorption rate and weighs approximately 2403 kg m 3 150 lb cf.
Glass filled nylon auger fastener with a 1 in.
Omg offers two fasteners specifically designed for securing insulation and membrane to structural concrete.
The normal weight concrete employs standard aggregates i e.
For complex reasons i am unable to do a test drilling and i need to come up with a best case worst case price range.
The concrete spike fastener is a one piece vibration resistant anchor designed to fasten insulation single ply roof membrane wood and steel to structural concrete roof decks.