This product comes with a.
Concrete exterior wall anchor tie down rings.
Anchor points are used to connect lanyards lifelines and other forms of tie off which prevent a worker from falling.
Finish area with liquid concrete.
1 weather proof cap and fasteners 2 waterproof flashing for both composite and tile roof and 3 non corrosive anchor.
Set the tie down anchor into the hole and hold it straight.
To give the area a finished look spread out some liquid concrete around the anchor.
1510 lone oak road eagan minnesota 55121.
If you are using no script on firefox or a similar add on extension on firefox or on any other browser you must enable it for this site.
Anchor points are usually installed on the roof but can also be installed on door and windows.
Place tie down anchor in concrete.
To install tap the anchor into a hole and tighten the bolt to expand the sleeve.
They re often used to hold steel and wood panels doors framing and shelving.
Before using concrete anchors or fasteners in an outdoor application it is imperative that the correct type of anchor is chosen.
As you tighten the nylon ring compresses to secure the fixture against the base.
You may need to use a small hammer to drive the anchor into the concrete.
Zinc plated wedge.
For 2 x 6 walls the bolt would be 2 3 4 inches from the outer edge and for 2 x 4 walls the anchor bolt would be 1 3 4 inches from the edge.
This piece has 2 fastening points and the ring is designed to stay centered in the trim collar for easy lift access california residents.
The large flip up d ring anchor point folds away when not in use and is versatile enough to accept most tie down end fittings.
When using anchors in applications where moisture salt or other chemicals are an issue the concrete fastener must meet certain requirements and be rust resistant.
Also known as sleeve anchors these have a sleeve that expands for a secure hold in block and brick.
Units which are designed to fix to concrete brick or masonry walls are normally supplied with some form of anchor bolt to provide a robust fixing.
This flush mount tie down ring is made of high strength steel plated with white zinc.
A hex head allows for a secure grip with a wrench.
Our selection of fall protection tie off anchor straps and adapters including cross arm straps anchor slings and choker anchors.
If you are using anchor bolts for concrete slabs or foundations it s important to place the bolt in the concrete so it s in the center of the wall.
Hold the anchor until it stands on its own.
The guardian fall protection truss boss anchor the guardian fall protection truss boss anchor kit is designed to be attached to the truss while on the ground in less than a minute.